This page will go over general rules & tips for sketching
Starting to sketch:
Select your service
Select the size range for your pipe
Select the drawing tool
Make sure it is highlighted green
Tap and drag to draw your pipe
Pulling Tees/Olets:
Have your base branch already drawn
Tap the tee/olet button on the right-hand side to pick your priority
Select the size of the pipe you want to pull off with
Tap the middle of the pipe and hold and drag to create a tee or olet
Small pipe sizes will also put in a reducing tee
Placing in Valves/Fittings:
Have your base branch already drawn
Select your menu on the left where the valve or fitting is
Select your valve/fitting from the menu
Place valve/fitting on the end of the pipe or cut into the pipe
